Dyson Vacuum Pulsing and Cutting Out, How to Fix It

If your Dyson keeps cutting in and out while you are vacuuming, that pulsing is the machine protecting itself, not a random fault. Dyson support says the machine will stop and start to alert you to a problem, and it does this to prevent the motor overspeeding when airflow is restricted. It will keep cutting in and out until the blockage is removed, so work through the steps below in order.

The fixes, in order

  1. Empty the bin and strip the machine back. Empty the bin below the MAX line, then remove all tools, the wand and the cleaner head.
  2. Check the wand and the cleaner head inlet for blockages. Look through both ends of the wand and into the cleaner head inlet. Also check the bin inlet flap moves freely, because fluff jamming it causes low suction and pulsing.
  3. Check the filter is fitted correctly. Make sure the filter is seated properly with a tight seal. If it is clogged, wash it and let it dry fully for 24 hours before refitting it.
  4. Tap the cyclone clean. Hold the cyclone over a bin and tap it gently, then brush dust from the cyclone shroud.
  5. Test it with nothing attached. With no tools, wand or head fitted, hold the trigger for 10 seconds. If it runs steadily, refit one part at a time until you find the part that brings the pulsing back.

If nothing works

If it still pulses with nothing attached, a clean filter and a clear bin inlet, the blockage may be inside the cleaner head, or the machine may need service. Contact Dyson support and tell them the pulsing continues with nothing attached.

Common questions

My Dyson keeps cutting in and out while I am vacuuming, why does it keep turning off and on? The pulsing is designed motor protection. When airflow is restricted, the machine stops and starts to stop the motor overspeeding. Empty the bin below MAX, check the wand and cleaner head inlet for blockages, check the bin inlet flap moves freely, and check the filter. It will keep cutting out until the blockage is gone.

Why does my Dyson pulse then stop? Pulsing means the machine has found restricted airflow and is protecting the motor. The usual causes are a full bin, a blocked wand or cleaner head, a jammed bin inlet flap, or a clogged filter. Work through the steps in order, and test with nothing attached to narrow it down.

Can I keep using the vacuum while it pulses? No. Stop and clear the blockage first. The machine will keep cutting in and out until the restriction is removed, and running it that way does not fix anything.

Related guides

Dyson Vacuum Flashing Lights Meaning · Dyson Vacuum Lost Suction · Dyson Vacuum Wont Charge · Dyson Brush Bar Not Spinning

Was this helpful?