Shark Vacuum Brush Roll Light Red, What It Means and How to Fix It

This is the one people usually say in a panic: "my Shark vacuum red light flashing and it stopped." The light itself does not tell you the whole story. When it came on does. A red light at the moment you start means the brush roll is jammed. A red light after a few minutes of running, with the vacuum stopping and feeling hot, means it overheated and shut itself off. Work out which case you have first, because the fix is different for each.

What the light means

Check your manual for your exact model. Indicator schemes vary by model and year, so the same light can mean something slightly different on another Shark. The timing rule above, jammed at start versus hot after running, holds across most models, but your manual is the final word for your machine. Always unplug the vacuum before you touch the brush roll.

The fixes, in order

  1. Unplug the vacuum. Do this before any of the steps below. Never reach into the brush roll area while the vacuum is plugged in.
  2. If the light is red at start, clear the jam. Flip the cleaner head over and cut away hair and string wrapped around the brush roll with scissors, taking care not to cut the bristles. Check for a broken belt, and make sure the floor mode is set to brush roll or carpet mode, not hard floor mode.
  3. If the light came on after minutes and the vacuum feels hot, let it cool. Unplug it, empty the dust cup, and check the hose, the airway and the filters for the blockage that caused the overheating. Then leave it to cool for 45 to 60 minutes before you try it again.
  4. If the headlights are flashing, re-seat the brush roll. Clear any clog from the roll, then check the roll is seated properly in the head and both sides of the floorhead lid are locked. A lid that is only locked on one side can keep the roll from turning.
  5. Plug it back in and test it. Run it briefly on a small patch of floor. If the light is solid green and the brush roll is spinning, you are done. If the red light comes back right away, go back to step 2 and look for a jam you missed.

If nothing works

If the light stays red after you have cleared the brush roll, checked the belt and let a hot vacuum cool fully, the problem is likely a broken belt, a worn brush roll motor or a fault in the cleaner head. Replacing the belt or the brush roll fixes most of these. If a new belt does not fix it, contact Shark support or a repair shop rather than running the vacuum hot.

Common questions

My Shark vacuum turned off by itself and will not start. What do I do? It most likely overheated and the thermal cutout tripped. Unplug it, empty the dust cup, check the hose, airway and filters for the blockage that caused it, and let it cool for 45 to 60 minutes before you try it again.

What does it mean when the headlights on my Shark vacuum are flashing? In most cases the brush roll is clogged. Unplug the vacuum, clear hair and string from the brush roll, then check the brush roll is seated properly and both sides of the floorhead lid are locked.

Is a solid red brush roll light dangerous? It means the brush roll is not turning, usually because it is jammed. Stop using the vacuum, unplug it, and clear the jam. Do not keep running it, because a stuck brush roll can strain the motor.

Related guides

Shark Vacuum Lost Suction · Browse the Index

Was this helpful?